Mōvi Carbon Specs

• Mōvi Carbon Travel Case
  • Qty 1 – Mōvi Carbon
    • Integrated* – Panasonic BGH1**, Panasonic BS1H** or Freefly Ember S5K
    • Fujinon XK 20-120mm Lens  (effective focal length depends on sensor size, see specs below per camera)
• Qty 1 – SL4 Battery Kit
  • Qty 2 – SL4-Ground Battery
  • Qty 2 – Mōvi Pro to SL Battery Plate Adapter
  • Qty 2 – SL Battery Charger (USB C)
  • Qty 2 – USB C to C Cable (2m/6.5ft)
• Qty 1 – 2.0mm Hex Driver
• Qty 1 – 2.5mm Hex Driver
• Qty 1 – Schneider Compact ND Kit 114mm (ND 0.6/0.9/1.2)
• Qty 1 – Schneider 4.5″ Round Clear Ultraviolet
• Qty 1 – Mōvi Ring Pro II

• Gimbal control (pan / tilt) and settings, camera start/stop and 3-axis lens control (focus / iris / zoom) controlled by Mōvi Controller and MIMIC + Bush Pilot****
• Full 3-axis pointing control (pan / tilt / roll) from the Mōvi Wheels (3-axis)** ***

• Panasonic BGH1
  • Captures 10bit 4k up to 60fps and FHD at 120fps, In V-Log L the BGH1 has 13+ stops of Dynamic Range
  • Effective zoom range with Fujinon XK 20-120mm Lens = ~40-240 mm
  • Remote Camera Control* – Run/Stop, ISO, WB, Shutter Angle and recording status
  • Remote (wired) camera control – Ethernet (included cable)
  • Video output – SDI (cable included)
  • Dual SD card slots**
  • Netflix Approved

• Panasonic BS1H
  • Captures 4k 12bit up to 60fps and FHD in 120fps (Super35 crop), In V-Log L the BS1H has 14+ stops of Dynamic Range
  • Effective zoom range with Fujinon XK 20-120mm Lens = ~32-192 mm (Super35 crop)
  • Remote Camera Control* – Run/Stop, ISO, WB, Shutter Angle and recording status
  • Remote (wired) camera control – Ethernet (included cable)
  • Video output – SDI (cable included)
  • Dual SD card slots**
  • Netflix Approved

• Freefly Ember S5K***
  • Captures 5k 600fps & 4k 800fps plus other aspect ratios and frame rates
  • Effective zoom range with Fujinon XK 20-120mm Lens = ~32-192 mm
  • Internal 4TB SSD (not swappable on set)
  • Remote Control – Run/Stop
  • Camera video output – HDMI (cable included)

Customized Fujinon XK 20-120mm lens for sharp, vivid images

Utilizing the Toad in the Hole receiver, Mōvi Carbon can be mounted to the included Mōvi Ring Pro II, or to anything you can mount a Toad to, including your Alta X, crane or 3rd party vehicle mounts.

Suggested accessories for a basic dual-op setup

Freefly Products

• Mōvi Controller
• • 13mm Dual Quick Release Mount
  • 13mm Mounts
• Secondary FIZ Controller
  • MIMIC + Bush Pilot (for handing a FIZ axis to 1st AC or DIT, not a substitute for the Mōvi Controller)
• 25mm Pop-n-Lock (For attaching Wireless Video TX to Mōvi Carbon)
• Mōvi Pro Landing Gear – For flying Carbon under Alta X or Alta 8

3rd Party Products

• SD Card for BGH1/BS1H (Class UHS-II or higher)
• Wireless Video RX/TX (transmitter with appropriate connector for camera)
• V-Mount Battery for Mōvi Controller

*Camera and lens are completely integrated into the Mōvi Carbon and cannot be removed for other uses. 

**Does not include removable solid state media

***Anticipated, but subject to change as development is finalized

****Mōvi Controller, MIMIC & Bush Pilot available separately. MIMIC can be used to give an additional operator control of a single lens axis, but not as a substitute for the Mōvi Controller for gimbal operations.

** ***Wheels cannot link directly to Carbon and will need either (optimally) a Mōvi Controller or a MIMIC for communication.